Planmeca PlanMill 50 S User Manual page 8

1 Introduction
2 Planmeca PlanMill 50 S
The Planmeca PlanMill 50 S milling unit is intended for the production of
dental indications and is specially developed to satisfy the requirements of
the dental industry.
The Planmeca PlanMill 50 S milling unit is intended for dry and wet
processing of the materials listed below.
Dry processing
Zirconium dioxide
Aluminium oxide
Plastics
Wax
Peek
Prefabricated CoCr abutments
Work pieces suitable for the Planmeca PlanMill 50 S, in disk sizes 98 mm
and 98,5 mm and blocks in different sizes from the materials listed above,
are available from Planmeca. Other materials are available on request and
require the express approval of Planmeca.
NOTE
Before using other materials!
Processing other materials is prohibited and requires separate approval and
permission from Planmeca. For further information please contact your local
dealer.
• The processing of highly flammable and inflammable materials is
prohibited!
• When processing titanium and other reactive materials, a general risk of
fire exists depending on the material! Perform an assessment to
determine the requirement for an automatic extinguishing system!
• Only use tools that are defined by Planmeca in the user's manual for the
milling unit, or that have been retrospectively approved (see section
"Milling tools" on page 21.)
• The milling unit must only be operated with approved cooling liquids from
Planmeca.
• An extraction system must be used in the application cases defined in
the user's manual. Only use extraction systems that are supplied or
approved by Planmeca.
• DRY processing with this milling unit shall only take place with an
extraction system.
• Wet processing with this milling unit shall only take place without an
extraction system.
• The milling unit must only be operated within the values specified in the
technical specifications, see section "Technical specifications" on page
113.
• Operation of the milling unit is only permissible if the protective devices
are functioning correctly, see section "Safety equipment" on page 19.
• The milling unit and components of the milling unit must only be
operated when in an operationally safe and technically faultless
condition.
Wet processing
Lithium disilicate
Glass-ceramic
Prefabricated titanium abutments
User's manual