General Cleanliness; Suitable Cleaning Products; Plastic Panels - Planmeca PlanMill 50 S User Manual

10 Service, maintenance and cleaning

10.3 General cleanliness

10.4 Suitable cleaning products

10.5 Plastic panels

78 Planmeca PlanMill 50 S
• Only use original replacement parts or replacement parts approved by
Planmeca!
• Use of replacement parts that have not been approved voids the
manufacturer's guarantee!
In case of ambiguities contact the local dealer.
Cleanliness increases the service life of individual parts and prevents
malfunctions.
Clean the unit regularly with a vacuum cleaner. Make sure no dirt gets into
the mechanics of the unit. Planmeca recommends the use of disposable
towels for cleaning away cooling liquid residues inside the milling unit.
The extraction unit supplied by Planmeca is only to be used for DRY milling
dust. The extraction of coolant residues with the Planmeca extraction unit is
not permitted and will damage the extraction unit.
Cleanliness and regular cleaning extend the service life of the milling unit.
Clean plastic windows and surfaces with a suitable liquid cleaner.
Never use abrasive cleaning products or cleaning products that attack
plastics, rubber or paint. These can damage (pneumatic) hoses, cables and
seals. Cleaning products can contain substances that are harmful to health.
Always observe the instructions of the respective manufacturer!
The milling unit operator must ensure that the cooling liquid and vacuumed
milling dust are stored and disposed of professionally and correctly. Observe
the legal regulations in this regard!
Cleaning with compressed air is not permitted as fine dust will permeate into
the mechanics and could cause damage.
Only use suitable cleaning products to clean the milling unit. Never use any
aggressive, caustic or flammable cleaning products. Cleaning products can
contain substances that are harmful to health.
Observe the instructions of the respective manufacturer in this regard.
NOTE
Cleaning products that attack plastics, rubber or paint must not be used.
These can damage (pneumatic) hoses, cables and seals!
The plastic panels consist of polycarbonate and must not be treated with an
abrasive plastic cleaner (liquid cleaner).
CAUTION
The plastic panels, which serve as guards inside the milling unit, must be
replaced in accordance with the German accident prevention regulations
(DGUV) with refer- ence to DIN EN 13218 after no more than two years, in
order to ensure the safe operation of the milling unit! If it is no longer
possible to observe the production pro- cess due to wear then the panels
must also be replaced!
User's manual