Annual Maintenance - Planmeca PlanMill 50 S User Manual

11.6 Annual maintenance

User's manual
2. Fill in the measured values (1, 2 and 3) to the appropriate fields in the 4.
Type in the measured values of the wall thickness section.
NOTE
Fill the correct milling body measurement results to the correct fields,
that is, the "three furrows" milling body results are filled on the left side
fields.
All the wall thickness values should be:
0.50 mm, with allowed tolerance of +/- 0.03 mm.
NOTE
If the Y-long or Y-short measurement results differs between the milling
bodies, contact your dealer for more instructions.
3. Click the Calculate button.
4. Click the Save and OK buttons to save the new values.
5. Click Exit button.
6. Mill another calibration body for confirmation of the changed values.
7. Repeat the process until the values are within tolerance.
The unit should be serviced once a year by personnel authorised by
Planmeca. This ensures a long service life and reliable operation.
11 Preventive maintenance
Planmeca PlanMill 50 S 95