In Case Of Emergency; In Case Of Fire; Dangers Due To High Temperatures - Planmeca PlanMill 50 S User Manual

4.6 In case of emergency

Freeing trapped personnel

4.7 In case of fire

4.8 Dangers due to high temperatures

User's manual
In situations in which there is a danger to persons or property, the user must
initiate an EMERGENCY STOP immediately (see also section "Description
of safety equipment" on page 19).
If persons are injured:
• Administer first aid
• Inform emergency doctor or medic
Freeing a person trapped in the milling unit's interior, e.g. due to trapping or
catching on a drive axis, takes place after pressing the EMERGENCY STOP
switch, in order to bring the milling unit to a standstill as quickly as possible
and analyse the hazardous situation!
Proceed as follows to release trapped personnel:
• Assess the condition of the trapped person and inform an emergency
doctor if necessary!
• Due to the low mass of the drives, it is possible to move the axes
manually when de-energised!
In case of fire, only extinguish this at the milling unit with a CO2 fire
extinguisher (carbon dioxide extinguisher). The use of extinguishers
containing water must be avoided with electrical systems for safety reasons!
In case of fire:
• Press EMERGENCY STOP
• Disconnect the power supply (fuse box)
• Notify the fire brigade
• Extinguish milling unit fire with CO2 fire extinguishers
NOTE
IMPORTANT INFORMATION!
Important information regarding the use CO2 fire extinguishers!
Before using a CO2 fire extinguisher, all persons must be warned and
evacuated! The person extinguishing the fire must wear respiratory
protection and be supplied with oxygen! After using the extinguishing agent,
ensure sufficient ventilation of the room before unprotected persons return to
it.
WARNING
Of hot surfaces on materials and tools!
Risk of burns on heated materials or tools after processing! During milling
unit operation, high temperatures may arise. Therefore ensure that surfaces
have cooled to ambient temperature before commencing all work or
activities. Tools, work pieces and chips may become very hot. Always wear
heat-resistant work clothing and protective gloves during work!
4 For your safety
Planmeca PlanMill 50 S 15