Maintenance Plan; Before Every Start-Up Of Unit; Daily; Weekly Or After Tool Breakage - Planmeca PlanMill 50 S User Manual

11.4 Maintenance plan

11.4.1 Before every start-up of unit

11.4.2 Daily

11.4.3 Weekly or after tool breakage

User's manual
3. Pull out the coolant tank.
4. Remove the coolant tank lid.
5. Fill or empty the coolant tank. The capacity of the coolant tank is 1.8
litres.
6. Close the coolant tank lid.
7. Make sure that the feed line and the float are in the uppermost position.
8. Push the coolant tank all the way to the back of the unit.
9. Push the feed line and the float downwards.
10. Make sure that the feed line and the float are positioned in the recess
provided in the lid of the coolant tank and that the function of the float is
guaranteed.
11. Close the coolant tank access door.
• Clean the workpiece holder
• Clean the tool holder
• Clean the tool shank on all tools
• Clean the length probe
• Clean the interior of the unit
• Check the water separator and empty if necessary
• Remove the collet chuck
• Clean the collet chuck
• Check the collet chuck for damage
11 Preventive maintenance
Planmeca PlanMill 50 S 87