Planmeca PlanMill 50 S User Manual page 78

9 Control software
Symbol
72 Planmeca PlanMill 50 S
Designation
Tool length
Minimum and maximum
tool length
Standard value for
maximum tool service life
Reset tool service life
Register tool in the
software
Delete tool
Cancel process
Confirm process
Warning symbol
Attention symbol
Tool length error
Description
Shows the current tool length.
Shows the defined minimum and maximum length of
the tool. If the tool lies outside these values, it is
marked with a warning symbol and blocked.
This button sets the predefined standard value for the
maximum tool service life (tool life) for this tool type.
Pressing this button resets the service life to "0". This
function must be used for example if an existing worn
tool is replaced with a new tool.
Resetting the service life signals to the software that
a new tool is now in the respective tool field.
This button opens a new window. Here, you can
change the tool type for the selected tool position and
register this in the software.
This button is used to delete the assigned tool.
This button can be used to cancel the current
process. Any changes made are not saved.
This button can be used to confirm the current
process. Any changes made are saved.
Signals that the tool is broken or lies outside the
defined tool length, after measuring.
Signals that the tool must be measured.
Indicates a tool length error. In this case, the tool
length is below or above the predefined minimum
value.
User's manual