Wet Processing - Planmeca PlanMill 50 S User Manual

8 Operating milling unit

8.7.2 Wet processing

50 Planmeca PlanMill 50 S
3. Plug the hose of the extraction system into the suction port.
4. Check that the extraction system is correctly connected.
5. Start the milling process with the extraction system switched on.
The following materials are generally wet-processed:
• Lithium disilicate
• Glass-ceramic
• Prefabricated titanium abutments
In order to start wet-processing a workpiece, proceed as follows:
1. Thoroughly clean the milling unit interior, the filter fleece chips and dry
milling dust (wear protective gloves and safety goggles throughout!).
2. Remove the suction funnel and fit the protective cap on the suction port.
3. Remove the cover from the drainage hole.
User's manual