General Hazards In The Workplace; Operator's Responsibility - Planmeca PlanMill 50 S User Manual

4 For your safety

4.9 General hazards in the workplace

4.10 Operator's responsibility

16 Planmeca PlanMill 50 S
WARNING
During operation the unit noise level in the work area is sufficient to cause
hearing damage.
• Always keep the work area clean
• Remove any unnecessary objects from the work area
• Mark any unavoidable tripping hazards with yellow-black marker tape
The operator is the person who uses the milling unit for commercial or
industrial purposes, or who commissions a third party with this, and who
bears the legal product responsibility for protecting the user, personnel or
third parties during its operation. The milling unit operator is subject to the
statutory obligations of industrial health and safety when using the milling
unit in commercial areas.
The operator and the personnel authorised by him (who receive special
instructions regarding hazards that may arise) are responsible for the fault-
free operation of the milling unit, and for clear stipulations regarding the
responsibilities when transporting, installing, operating, maintaining and
cleaning the milling unit. In addition to the safety instructions and information
in this user's manual, it is also necessary to observe and adhere to the local
accident prevention regulations and the general health and safety
provisions, as well as the valid environmental protection regulations relevant
to the area of use of the milling unit.
NOTE
Observe the information in the user's manual fully and without limitation!
NOTE
IMPORTANT INFORMATION!
Important instructions for the milling unit operator!
Read this user's manual through carefully before connecting, starting up and
operating the milling unit!
As with all technical systems, it is only possible to guarantee the faultless
functionality and operational safety of this milling unit if the generally
applicable safety precautions and the special safety instructions in this
user's manual are observed during its operation!
1. The milling unit installation and commissioning must be performed by an
authorised Planmeca service technician.
2. The milling unit must be used exclusively in accordance with the
following instructions. We accept no liability for damage caused by use
of the milling unit for any other applications.
3. The milling unit must only be operated with materials and accessory
parts approved by manufacturer. The use of materials or accessory parts
(e.g. milling cutters) that have not been approved may result in damage
to the milling unit or to the work produced. We accept no liability in this
instance.
4. Before starting up the milling unit, ensure that the mains voltage
specified on the type plate for the individual components is the same as
User's manual