Wet Milling - Planmeca PlanMill 50 S User Manual

8.18.2 Wet milling

User's manual
3. Fit the extractor funnel onto the extraction nozzle.
4. Connect the extraction unit to the milling unit using the cable provided.
5. Check the proper connection of the extraction unit.
6. Start the milling process.
Follow the steps below before starting wet milling.
1. Open the milling chamber lid.
2. Remove the extraction funnel.
3. Close the extraction nozzle by placing the protective cap onto it.
4. Start the milling process (for instructions see both "Wet processing" on
page 50 and "Milling" on page 59).
8 Operating milling unit
Planmeca PlanMill 50 S 61