Analysis Setup - Thermo Scientific MIRAN 205B Series Instruction Manual

ANALYSIS SETUP PAGE 3
To continue with the analysis setup, press the down arrow key from the second Analysis
Setup Menu. The third Analysis Setup Menu, shown below, is displayed.
The current application setup summary is displayed on the left and the menu of selections
on the right.
Passcode
To turn the passcode on or off or to change the passcode, press
third Analysis Setup Menu. The Passcode Menu is displayed. Press
passcode feature off,
If is pressed, the display requires entering the new passcode. The passcode can contain
3
from 1 to 10 digits. After entering the new passcode, press the
password is accepted, enter the password again to verify it. If this is also valid, the
display responds "-ACCEPTED-."
Log Capacity
To configure the log capacity, press
Menu. The Log Capacity Menu is displayed. Press
sites and to specify the maximum number of locations per site. The maximum number
2
of sites can be from 1 to 50 and the maximum number of locations per site, from 1 to
200.
┌────────────────────────────────────────┐
│╒════════SUMMARY════════╕ANALYSIS SETUP │
││ Passcode: Off
││ ─────
││ Capacity: 50/200
││Locations: Off
││Reprt Out: As logged
││
│└───────────────────────┘
└────────────────────────────────────────┘
Analysis Setup Page 3 Menu
to enable the feature, or
2
(Log capacity) from the third Analysis Setup
2
Chapter 7 Configuration and Setup
│1=Passcode
│ ─────
│2=Log capacity │
│3=Location list│
│4=Report output│
│
=More
1
to change the code.
3
ENTER
to specify the maximum number of
1
7-19
│
│
│
│
(Passcode) from the
to turn the
1
key. If the