┌────────────────────────────────────────┐
│╒════════STATUS═════════╕ DATA TRANSFER │
││
││
││Locations: ---
││
││
││
│└───────────────────────┘3=Send/receive │
└────────────────────────────────────────┘
┌────────────────────────────────────────┐
│╒════════STATUS═════════╕ DATA TRANSFER │
││
││
││Locations: ---
││
││
││
│└───────────────────────┘
└────────────────────────────────────────┘
Automatic and Manual Data Transfer Menus
Connect the analyzer to the computer with a serial communication cable. Verify that the
baud rate on the analyzer and that on the computer match. A baud rate of 19200 is
considered standard. In PCIP, press
Type a file name (for example, "MYSETUP.TXT"). As it is being typed, the file name
appears at the bottom of the screen. Press
ThermoConnect is being used, press
Uploading New Firmware
With the analyzer running, press the Firmware Update Switch on the analyzer with a thin
rod such as a paper clip (see Figure 3-8 for location). The Firmware Update menu is
displayed. Press the applicable number to select a language.
╔════════════════════════════════════════╗
║─────────────FIRMWARE UPDATE────────────║
║
║
║
║
║
║
║
╚════════════════════════════════════════╝
Press
to continue to the Firmware Main Menu.
ENTER
Site: <all>
Memory: 94% free
Site: <all>
Memory: 94% free
for file, and select the directory to store the file.
F2
ENTER
F5=Receive
Select language: 1=English 2=Francais ║
3=Espanol 4=Deutsche ║
Enter=Continue
Firmware Update Menu
11-3
Chapter 11 Firmware Update
│
Mode=Auto
│
│
Baud=9600
│
│
│
│
│
│1=Change mode
│
│2=Change baud
│
│
Mode=Manual │
│
Baud=38400
│
│
│
│1=Change mode
│
│2=Change baud
│
│
3=Send
│
4=Receive
│
to end the file name. If
, and then
F6=Full Setup
1.00║
║
║
║
║
.