Data Transfer - Thermo Scientific MIRAN 205B Series Instruction Manual

While printing, an indicator shows the percentage complete. When complete, the message
"Print Transfer Okay" is displayed. If unable to print the report, the analyzer displays the
message "Printing Failed."

DATA TRANSFER

To transfer data, connect the analyzer to a computer with an RS-232 cable and press
(Data transfer) from the Report/Data Menu. One of two Data Transfer Menus (one for
auto data transfer mode and one for manual data transfer mode) is displayed (see Data
Transfer Menus, below). The current status is shown on the left. The current mode and
baud rate is shown on the right as well as the opportunity to change the mode or baud rate
and to send or receive data.
Change Mode
To change mode, press
or 2 = Manual.
Change Baud Rate
To change baud rate, press
1 = 19200, 2 = 9600, 3 = 4800, 4 = 2400, or 5 = 1200.
┌────────────────────────────────────────┐
│╒════════STATUS═════════╕ DATA TRANSFER │
││ Site: <all>
││
││Locations: ---
││
││
││ Memory: 94% free
│└───────────────────────┘3=Send/receive │
└────────────────────────────────────────┘
┌────────────────────────────────────────┐
│╒════════STATUS═════════╕ DATA TRANSFER │
││ Site: <all>
││
││ Locations: ---
││
││
││ Memory: 94% free
│└───────────────────────┘
└────────────────────────────────────────┘
Data Transfer Menus
(Change mode) from the Data Transfer Menu. Select 1 = Auto
1
(Change baud) from the Data Transfer Menu. Select
2
│ Mode=Auto
│ Baud=9600
│
│
│1=Change mode
│2=Change baud
│ Mode=Manual │
│ Baud=38400
│
│1=Change mode
│2=Change baud
│ 3=Send
4=Receive
9-3
Chapter 9 Report/Data
3
│
│
│
│
│
│
│
│
│
│
│
│