Gas Data - Thermo Scientific MIRAN 205B Series Instruction Manual

GAS DATA

The main part of the report is the gas data section. It reports data for each location. In the
coded format, it begins with the words GAS DATA and ends with the word END. The
standard printed format is shown in Figure 14-1 and the same format as coded in Figure
14-2.
REPORT-GAS DATA-SINGLE SAMPLE LOG
~~~~
~~~~
~~~~
~~~~
~~~~
~~~~
~~~~ LOCATION
~~~~------------
{H{D\#15~~~~~~~~
}}\
END
The coding in Figure 14-2 is explained as follows:
Code
{D} Repeat for all logged data for a location.
{G} Repeat for each gas for one location.
Repeat for all logged locations that are sequential and exactly the same except for
{H}
the location and data logged.
| Center data within field with leading and trailing spaces.
~ May be ignored; for definition readability/layout only
\@30 Gas name
\@31 Gas High Range Limit
\#00 Date in format DDMMMYY
\#10 Time in format HH:MM:SS
\#15 Location
\#20 Maximum Concentration
\#21 Minimum Concentration
\#22 Average Concentration
\#24 Concentration Unit
\#45 Fault Flag
\#46 High Alarm Flag
\#47 Low Alarm Flag
{G |
{G |
DATE/TIME {G | MAX
----------------{G ------ ------ ------ ------~~~~~~~}
\#00~~~ \#10~~~~{G \#20~~ \#21~~ \#22~~ \#45\#46\#47 }
Figure 14-2. Gas Data Standard Coded Format
Table 14-2. Codes Used in Standard Format
14-3
Chapter 14 Custom Report Formatting
\@30|~~~
HRL: \@31~~ \#24
MIN AVG FLAGS|~~~~~~~~}
Meaning
|~~~~~~~~~}
|~~~~~~~}