How To Run An Analysis; Creating A Method - Thermo Scientific iCAP 6000 Series User Manual

How to Run an
Analysis

Creating a Method

Thermo Fisher Scientific
Below is an example of a simple analysis for determining concentrations
of an element in some unknown samples. A blank and one standard will
be used for calibration.
The first step is to create a new method for the analysis which uses the
default parameters within iTEVA. This method setup procedure should
be adequate for setting up a basic analysis. It is recommended that the
user reads the iCAP Software Manual for more advanced use of the
system.
In the iTEVA Analyst software select New...
Firstly, you will be prompted to choose the elements you are analysing.
In this case you will click on Al Al Al Al and accept the default line by clicking
OK. Once you have chosen your element(s) click OK OK
OK OK
up your method.
Using the iCAP

How to Run an Analysis

New... from the Method New... New... Method menu. Method Method
OK and you can set
OK OK
iCAP User Guide
4-5