Chapter 7 Configuration and Setup
Next, the Gas Unit Menu is displayed (see Gas Unit menu, below). The current
application is displayed on the left and the menu of selections on the right. Choose Select
the unit from the menu. Press
If one of the above units is selected the user is asked to further specify how long the
selected units should be used. 1 = Always and 2 = Until another application is selected.
The display then summarizes the selections and indicates ACCEPTED.
CLOCK
Selecting 4 = Clock from the Setup Menu causes the Clock Menu to be displayed (see
Clock Menu, below). The current clock reading is displayed on the left and a place to
enter the new date on the right. See Chapter 4, "Entering Alpha Characters" for entering
the letters of the month. Pressing
similar display to change the time. After setting the time and pressing
display responds "-ACCEPTED-."
to set all gases to their default unit.
ENTER
┌────────────────────────────────────────┐
│╒══CURRENT APPLICATION══╕Select unit:
││ METHANE: ---- ppm
││
ETHANE: ---- ppm
││
BUTANE: ---- ppb
││ PROPANE: ---- ppm
││
HEXANE: ---- ppm
││GROUPTWA: ---- %
│└───────────────────────┘ Enter=Default │
└────────────────────────────────────────┘
Gas Unit Menu
ENTER
┌────────────────────────────────────────┐
│╒═════════CLOCK═════════╕Enter new date:│
││
││
││Clock: 04Jan01 13:30:46│
││
││
││
│└───────────────────────┘ Enter=Accept
└────────────────────────────────────────┘
Clock Menu
│
│1=ppb
│2=ppm
│3=percent
│4=mg/m^3
│
to accept the new date changes the screen to a
│
│
11Jan01
│
│
│ =Backsp
7-6
│
│
│
│
│
│
│
, the
ENTER
│
│
│
│
│
=Next│
│