Thermo Scientific MIRAN 205B Series Instruction Manual page 76

Chapter 7 Configuration and Setup
User Settings
User Settings modify the parameters of the selected application that do not impact
application performance. This involves selecting the gas if it is a multi-gas application
and then configuring the gas unit, high alarm, low alarm, STEL alarm, and STEL time for
any application. A flow chart of the configuration is shown in the User Settings flow
chart, below.
Note: These are the only parameters that may be changed in standard library
applications.
To access this function, press
a multi-gas application, the Select Gas Menu is displayed (see Select Gas menu, below).
If it is a single gas application, the Set Parameters Menu is displayed (see Set Parameters
menu, below). If it is a multi-gas application, when one of the gases listed in the Select
Gas Menu is selected, the display proceeds to the Set Parameters Menu.
Figure 7-2. User Settings Flow Chart
(User settings) from the Application Setup Menu. If it is
2
┌────────────────────────────────────────┐
│╒════════SUMMARY════════╕Select gas:
││
││
││ Applic: METHANE
││
││
││
│└───────────────────────┘
└────────────────────────────────────────┘
Select Gas Menu
┌────────────────────────────────────────┐
│╒════METHANE SUMMARY════╕
││ HRL: 100.0ppm
││High: 100.0ppm
││ Low: 50.00ppm
││STEL: 5.00ppm @ 15min│3=Low alarm
││TwaWt: Off
││MolWt: 16.0
│└─────────Gas1──────────┘5=STEL time
└────────────────────────────────────────┘
Set Parameters Menu
│1=METHANE
│2=ETHANE
│3=BUTANE
│4=PROPANE
│5=HEXANE
│6=GROUPTWA
METHANE
│1=Unit
│ ─────
│2=High alarm
│4=STEL alarm
D: Off │ ─────
7-22
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│