Sites And Locations Summary - Thermo Scientific MIRAN 205B Series Instruction Manual

4. Since standard locations and supplemental locations are loaded from a PC and are
"permanent", the only way to remove these is to clear the entire memory. To clear
all memory, press
Report/Data menu. At the Memory Menu, press
locations, -report defin). Please note that performing this function does not
remove the report format from the analyzer, it loads the default report format from
flash memory. If a custom report format was used, it must be reloaded.
5. It is possible to create several location files and send them into the analyzer as
needed (the one being sent into memory overwrites the exiting one). This may be
helpful if the monitor patterns include homes (examples provided earlier),
hospitals (locations may be OR1, OR2, Recovery1, Sterilizer1) or painting
operations (spray booth1, vent hood1, drying area, storage room).

SITES and LOCATIONS SUMMARY

A site is a memory location that holds logged data and has a limited life. It must be
created to log data and take a few seconds to establish. Locations come in various types,
and may be either permanent or temporary. It takes a more substantial effort to develop
them, but the standard and supplemental locations are reusable. Below is a block diagram
that represents how they interact.
PERSONAL COMPUTER
LEGEND
(Report / Data), then select
5
MEMORY
Figure 8-1. Sites and Locations Block Diagram
(memory clear) from the
4
(clear all: -logged data, -
2
SapphIRe ANALYZER
8-5
Chapter 8 Site Info