OdaLog® L2 – Gas Logger User Manual
Open the OdaStat-G™ software package on your PC and ensure communication settings are
configured correctly to communicate with your OdaLog® instrument (refer to OdaStat-G™
software package Help).
Place OdaLog® into IrDA Mode.
Position the IrDA device between 25-150mm (1-6") from the OdaLog® Instrument, ensuring line-
of-sight between the IrDA device and the IrDA module on the OdaLog®, as shown in Figure 9.
Disconnect the instrument when finished.
6.9. Switching off
Press and hold the button down and wait for the display to cycle through the screens until "OFF2" is
displayed. Keep the button depressed until the display counts down from "OFF2" to "OFF", then release
the button.
When the button is correctly released to turn the instrument off, the OFF title will shift one character to
the right to confirm that the instrument is now in the off state.
Note 1: This can only be done when logging is stopped unless Auto Log Start is active (see Section 6.7).
Note 2: Releasing the button during the countdown routine will cause an exit to the instantaneous screen.
P/N: 10-1000
Figure 9:Setup of IrDA Communication
Figure 10: Display during Switching OFF.
Revision G, January 2024
(Release Button)
(The 'OFF' title will
shift to the right)
Page | 14