Making The Measurement - Agilent Technologies E5500A User Manual

Making the
Measurement
Residual Measurement Examples
Amplifier Measurement Example
Residual Connect Diagram Example
Calibrate the Measurement using Measured +/- DC Peak Voltage
Refer to Chapter 8, "Residual Measurement Fundamentals"
information about residual phase noise measurements calibration types.
Procedure
1. Connect circuit as per
connections.
2. Measure the power level that will be applied to the Signal Input port of
the Agilent/HP 70420A's phase detector. The following chart shows the
acceptable amplitude ranges for the Agilent/HP 70420A phase detectors.
9-10 Agilent Technologies E5500 Phase Noise Measurement System
Figure 9-2 on page 9-11, and tighten all
for more