Table of Contents
Advertisement
Required Equipment
How to Begin
E5500 Operation; A Guided Tour
This measurement demonstration will introduce you to the system's
operation by guiding you through an actual phase noise measurement.
You will be measuring the phase noise of the Agilent/HP 70420A test set's
internal noise source. (The measurement made in this demonstration is the
same measurement that is made to verify the system's operation.)
As you step through the measurement procedures, you will soon discover
that the phase noise measurement system offers enormous flexibility for
measuring the noise characteristics of your signal sources and two-port
devices.
The equipment shipped with this system is all that is required to complete
this demonstration. (Refer to the E5500 Installation Guide if you need
information about setting up the hardware or installing the software.)
Follow the set up procedures beginning on the next page. The phase noise
measurement system will display a setup diagram that shows you the correct
front panel cable connections to make for this measurement.
Agilent Technologies E5500 Phase Noise Measurement System 3-3
Your First Measurement
E5500 Operation; A Guided Tour
Advertisement
Table of Contents
