Table of Contents
Advertisement
Figure 12-7
NOTE
Figure 12-8
Method 1: User Entry of Phase Detector Constant
AM Noise Calibration Setup
3. Locate the drive level on the AM sensitivity graph (figure 3-5), and enter
the data.
4. Measure the noise data and interpret the results. The measured data will
be plotted as single-sideband AM noise in dBc/Hz.
The quadrature meter should be at zero volts due to the blocking capacitor at
the AM detector's output.
AM Detector Sensitivity Graph
Agilent Technologies E5500 Phase Noise Measurement System 12-9
AM Noise Measurement Fundamentals
Advertisement
Table of Contents
