Agilent Technologies E5500A User Manual page 350

Table 13-3 Parameter Data for the AM Noise using an Agilent/HP 70420A Option
001
Step Parameters
4 Block Diagram Tab
• Source
• AM Detector
• Down Converter
5 Test Set Tab
• Input Attenuation
• LNA Low Pass Filter
• LNA Gain
• Detector Maximum Input
Levels
Microwave Phase Detector
RF Phase Detector
AM Detector
• Ignore out-of-lock conditions
• Pulsed Carrier
• DC Block
• Analyzer View
• PLL Integrator Attenuation
6 Dowconverter Tab
7 Graph Tab
• Title
• Graph Type
• X Scale Minimum
• X Scale Maximum
• Y Scale Minimum
• Y Scale Maximum
• Normalize trace data to a:
• Scale trace data to a new
carrier frequency of:
• Shift trace data DOWN by:
• Trace Smoothing Amount
• Power present at input of DUT
Agilent Technologies E5500 Phase Noise Measurement System 13-11
AM Noise Measurement Examples
AM Noise using an Agilent/HP 70420A Option 001
Data
• Manual
• TestSet AM Detector
• None
• Auto checked
• Auto checked
• Auto Gain
• 0 dBm
• 0 dBm
• 0 dBm
• Not checked
• Not checked
• Not checked
• Baseband
• 0.00 dBm
• Does not apply to this measurement example.
• AM Noise Measurement of an RF Signal
• AM Noise (dBc/Hz)
• 10 Hz
• 100E + 6 Hz
• 0 dBc/Hz
• - 180 dBc/Hz
• 1 Hz bandwidth
• 1 times the current carrier frequency
• 0 dB
• 0
• 0 dB