Agilent Technologies E5500A User Manual page 33

Your First Measurement
Making a Measurement
Table 3-1 Parameter Data for the Agilent/HP 70420A Confidence Test Example
Step Parameters
1 Type and Range Tab
Measurement Type
• Start Frequency
• Stop Frequency
• Minimum Number of Averages
FFT Quality
Swept Quality
2 Cal Tab
• Gain preceding noise input
3 Block Diagram Tab
• Noise Source
4 Test Set Tab
Input Attenuation
LNA Low Pass Filter
• LNA Gain
• DC Block
• PLL Integrator Attenuation
5 Graph Tab
• Title
• Graph Type
• X Scale Minimum
• X Scale Maximum
• Y Scale Minimum
• Y Scale Maximum
• Normalize trace data to a:
• Scale trace data to a new
carrier frequency of:
• Shift trace data DOWN by:
• Trace Smoothing Amount
• Power present at input of DUT
1. The Stop Frequency depends on the analyzers configured in your phase noise system.
3-10 Agilent Technologies E5500 Phase Noise Measurement System
Data
• Baseband Noise (using a test set)
• 10 Hz
1
• 100 E + 6 Hz
• 4
• Fast
• Fast
• 0 dB
• Test Set Noise Input
• 0 dB
• 20 MHz (Auto checked)
• Auto Gain (Minimum Auto Gain - 14 dB)
• Not checked
• 0 dBm
• Confidence Test, Agilent/HP 70420A
Internal Noise Source.
• Base band noise (dBv/Hz)
• 10 Hz
• 100 E + 6 Hz
• 0 dBv/Hz
• - 200 dBv/Hz
• 1 Hz bandwidth
• 1 times the current carrier frequency
• 0 dB
• 0
• 0 dB