Step 5: Verify Operation Of The U5303A Module - Agilent Technologies U5303A Startup Manual

Step 5: Verify Operation of the U5303A Module

The intention of this step is to verify correct operation of the newly installed module. Run Agilent Connection
Expert by right-clicking the task bar icon
It will display the modules that are installed. Review the configuration data and then launch the SFP. This will
provide control of the module for self test and other operational verification procedures.
Agilent U5303A Instrument Properties
Agilent U5303A Installed Software
Agilent U5303A Startup Guide
, and select Agilent Connection Expert.
Step 5: Verify Operation of the U5303A Module
The instrument properties may
be viewed by clicking on the
desired instrument and then on
the Instrument Properties tab
in the right pane.
If the module
does not appear in the Agilent
Connection Expert, first try the
'Refresh All' button. If that
does not work, restart your PC
or embedded controller and
start Agilent Connection Expert
again.
A verification utility may be
launched by selecting the
Installed Software tab, selecting
the 'SFP - Verify Operation' item
and then clicking on Start SFP.
17