Memory; Monitors - HP Visualize c3700 Owner's Manual

Overview
Product Information

Memory

The B2000 workstation has four slots for memory DIMMs. You can
install only 128 MB, 256 MB, or 512 MB DIMMs in these slots. The
minimum memory configuration for a B2000 workstation is 256 MB, and
the maximum is 2 GB.
To install memory DIMMs in your workstation, follow the procedure in
the "Installing Additional Memory" on page 132. Please keep in mind
that if memory is installed improperly or if it is bad, your workstation's
operating system will not boot-up, and a DIMM error message will
appear on your workstation's LCD. If a DIMM error does occur, please
refer to the "Memory Failures" section in Chapter 6.

Monitors

Your HP monitor should be set to one of the following resolutions:
• 1280 1024 color (stereo capable), 75Hz, VESA
• 1600 1200 color, 75Hz, VESA
• 1280 1024 color, 75 Hz, VESA
Your workstation must have either an HP-supported monitor running at
75 Hz with a 1280 1024 resolution, or a full multi-mode color monitor.
Monitors with EVC, D-Sub, or 5 BNC connectors (RGB, vertical sync,
horizontal sync) will function.
NOTE
The HP V fxe graphics card will not function with older HP
ISUALIZE
monitor types that use a sync on green signal. This includes monitors
such as the HP 1097A/B/C/D, A2088A, and A2828A/B that only have 3
BNC connectors.
Note that you can connect the B2000 workstation to earlier HP monitors
with 15-pin miniature D-Sub cables using the A4168A adapter shipped
with your workstation's accessory kit.
Before using your monitor, you should become familiar with its controls,
connectors, and indicators. For information about using your monitor, see
the documentation that came with the monitor.
Chapter 1 31