Installing A Hard Disk Drive - HP Visualize c3700 Owner's Manual

NOTE

Installing a Hard Disk Drive

This procedure explains how to install your hard disk drive in the slot
that has been preassigned SCSI ID 5. On internal hard disk drives, the
slot determines the addressing. There are no cables required when
installing a hard disk drive. Note that to install the hard disk drive, your
workstation must be turned off.
If you are installing a hard disk drive, you will need to mount it and
create a file system on it. See "Configuring a Hard Disk Drive as a File
System" on page 127. This should be done after you have installed the
hard disk drive.
To mount a hard disk drive and create a file system on it use the
procedure provided in the section "Adding a Hard Disk Drive as a File
System Using SAM" found in this chapter.
1. Remove the side panel of your workstation using the instructions
found in the section "Opening the Side Panel." As you face the
workstation system board, the hard disk drives are on the right side.
The hard disk drive plugged into the lower SCSI connector (ID 5) is
the one discussed in this section. See Figure 4-36.
Chapter 4
Changing Your Workstation's Hardware Configuration
Hard Disk Drives
117