Hard Disk Drives - HP Visualize c3700 Owner's Manual

Changing Your Workstation's Hardware Configuration

Hard Disk Drives

Hard Disk Drives
This section describes how to install a hard disk drive in your
workstation and how to remove it from your workstation. The first
section details how to install a hard disk drive. The second section details
how to remove a hard disk drive. The final section explains how to
configure your hard disk after it is installed.
Your workstation can have two internal hard disk drives. These internal
hard disk drives are devices on the Ultra2 Wide Low-Voltage Differential
SCSI bus. The hard disk drive that came with your workstation was set
to SCSI ID 6 on the Ultra2 Wide Low-Voltage Differential SCSI bus. If
you are adding a second internal hard disk drive, the second hard disk
drive will use SCSI ID 5 on the Ultra2 Wide Low-Voltage Differential
SCSI bus. Note that the two slots for the hard disk drives have SCSI ID
numbers 5 and 6 preassigned to them and SCSI ID 6 is the system disk.
You will not be able to change these SCSI ID numbers.
CAUTION Hard disk drives are susceptible to mechanical and electronic shock.
When handling the drive, always wear the static-grounding wrist strap
that came in the disk drive kit. Always handle the drive carefully.
116 Chapter 4