Monitor Type; Setting The Monitor Type At Power On - HP Visualize c3700 Owner's Manual

Monitor Type

Your workstation ships from the factory preset to use a monitor with a
specific resolution and frequency. If you replace your monitor with a
different type, you must reconfigure your workstation to support it.
There are three ways to configure your workstation to support a different
monitor type. They are discussed in the subsequent sections.

Setting the Monitor Type at Power On

If you replace your workstation's monitor with a different type of
monitor, and you have not set the workstation's graphics parameters by
using the Boot Console Interface's monitor command, you can still
configure your workstation's new monitor type when you reboot the
workstation.
To set the monitor type, you will need to:
1. Press the key after your keyboard's Num Lock light comes on
Tab
during the boot process to initiate the automatic monitor selection
process. Your system will query you for a new monitor type. Note that
if you have waited more than 2 minutes for a monitor type to appear,
go to the section "Troubleshooting Monitor Problems" in this chapter.
2. Select one of the monitor types listed on the screen and press
your monitor is not listed in the section "Monitors" in Chapter 1,
"Overview," a common monitor type to select is 12.
3. Answer yes, by pressing
selection. Note that if you do not make a selection, the workstation
cycles through a limited number of monitor types continuously until
you do make your selection. See the section "Displaying and Setting
the Monitor Type" on page 163.
Chapter 4
Changing Your Workstation's Hardware Configuration
, to the system query to confirm your
Y
Monitor Type
. If
Enter
141