Removable Media Devices; Installing A Cd Drive - HP Visualize c3700 Owner's Manual

WARNING
CAUTION
Changing Your Workstation's Hardware Configuration

Removable Media Devices

Removable Media Devices
There are only two internal removable media devices allowed in a B2000
workstation:
• CD drive
• 3.5-inch floppy disk drive.
The procedures provided in the subsequent sections explain how to
install and remove removable media devices.

Installing a CD Drive

Install the CD drive by following the procedure covered in this section.
Turn the workstation off and unplug the power cord before
installing the CD drive.
Note that the installed CD drive will not need any jumpers set on the
back of your CD drive, as they are set at the factory. However, if you
bought a new CD drive to install in your workstation, you will have to
make sure that the master/slave/CSEL jumper is set in the CSEL
position. Since different manufacturers of CD drives have different
locations for the CSEL jumper, look at the documentation that comes
with your CD drive for the proper location of this jumper.
CD drives are susceptible to mechanical and electronic shock. When
handling the drive, always wear the static-grounding wrist strap that
came in the CD drive kit. Always handle the drive carefully.
1. Perform the procedures in the sections "Opening the Front Panel" and
"Opening the Left Side Panel." The front panel needs to be opened so
you can insert the CD drive into its proper location in the chassis. The
left side panel needs to be opened so you can get to the CD drive's
audio, ATAPI and power connectors.
88 Chapter 4