Troubleshooting Monitor Problems - HP Visualize c3700 Owner's Manual

Troubleshooting Monitor Problems

In the event that your console stops displaying to your graphics device,
use the following procedure to set the console for displaying to an
external terminal.
Here are the steps to follow:
1. Power off the workstation.
2. Disconnect the workstation's keyboard connector from the rear panel.
3. Connect a serial terminal emulator to the Serial 1 connector (the left
serial connector) on the rear panel.
4. Power on the workstation. The workstation will now display the
console to the terminal connected to Serial 1 port. Note that you can
use a 9-pin to 9-pin serial cable (HP F1044-80002) to connect an HP
OminiBook serial port to the workstation.
5. Set the monitor type and path using the Boot Console Interface. For
information see Chapter 5, "Displaying and Setting the Monitor
Type" on page 163.
Chapter 4
Changing Your Workstation's Hardware Configuration
Monitor Type
145