Installing A Floppy Disk Drive - HP Visualize c3700 Owner's Manual

WARNING
CAUTION
8. Replace the plastic CD drive blank in the workstation's front panel.
9. Replace the left side panel and front panel of the workstation as
explained in the sections "Closing the Left Side Panel" and "Closing
the Front Panel" in this chapter.

Installing a Floppy Disk Drive

Install the floppy disk drive by following the procedure covered in this
section. Note that there are no jumper settings required for the
installation of the floppy disk drive.
Turn the workstation off and unplug the power cord before
installing the floppy disk drive.
Floppy disk drives are susceptible to mechanical and electronic shock.
When handling the drive, always wear the static-grounding wrist strap
that came in the floppy disk drive kit. Always handle the drive carefully.
1. Perform the procedures in the sections "Opening the Front Panel" and
"Opening the Left Side Panel." The front panel needs to be opened so
you can insert the floppy disk drive into its proper location in the
chassis. The left side panel needs to be opened so you can get to the
floppy's data connector and its power connector.
Chapter 4
Changing Your Workstation's Hardware Configuration
Removable Media Devices
101