WARNING
Changing Your Workstation's Hardware Configuration
Memory Cards
Memory Cards
This section contains information regarding the installation and removal
1
of memory (DIMM
please take time to read the following list of considerations:
• Use the procedure described in Chapter 5, "The Boot Console
Interface," to determine the current memory configuration for this
workstation. This should be done before trying to install additional
memory DIMMs in your workstation.
• Read over the steps in the section "Installing Additional Memory"
before you begin the installation of your DIMM cards.
Installing Additional Memory
Perform the following steps to add memory (DIMM cards) to your
workstation.
Turn the workstation off and unplug the power cord before
installing additional memory.
1. Open the side panel of the workstation as explained in the section
"Opening the Left Side Panel" on page 78 in this chapter.
1. Dual In-Line Memory Module
132
cards). However, before continuing with this section,
Chapter 4