Installing I/O Cards - HP Visualize c3700 Owner's Manual

Figure 4-8
NOTE
Removing the I/O Card
I/O Card
Bulkhead
Screw
I/O Card
Bulkhead
5. Pull evenly on the outside edges of the I/O card to remove it. See
Figure 4-8.

Installing I/O Cards

To install an I/O card into your workstation, follow these steps.
The built-in V
ISUALIZE
Use the secondary graphics slot (PCI slot 1) for the highest performance
graphics card and PCI slot 2 for the second graphics card and then any of
the remaining 32 bit slots for the third PCI graphics card.
1. Open the left side panel of the workstation as explained in the section
"Opening the Left Side Panel" in this chapter.
2. Locate the appropriate slot for the I/O card that is to be installed. See
Figure 4-3.
3. Unscrew the T-15 Torx screw and remove the bulkhead blank of the
slot you have chosen. If no blank is present, you may skip to step four.
4. Pull evenly in the direction of the arrow on both PULL tabs of the I/O
card retainer to remove it. See Figure 4-7.
5. Insert the I/O card into the slot you have chosen with the bulkhead
Chapter 4
Changing Your Workstation's Hardware Configuration
fxe graphics is the primary graphics slot (slot 0).
I/O Card Being Removed
I/O Cards
85