Removing A Hard Disk Drive - HP Visualize c3700 Owner's Manual

NOTE
Figure 4-42

Removing a Hard Disk Drive

This procedure explains how to remove your hard disk drive. Note that
there are no cables to disconnect when removing a hard disk drive. To
remove a hard disk drive, your workstation must be turned off.
If you are removing a hard disk drive that has a mounted file system on
it, you will need to unmount it. This should be done before you remove
the hard disk drive.
To unmount a file system on a hard disk drive use the procedure
provided in the section "Removing a Hard Disk Drive as a File System
Using SAM" found in this chapter.
1. Open the side panel of your workstation using the instructions found
in the section "Opening the Side Panel." As you face the workstation
system board, the hard disk drives are on the right side. The lower
slot (ID5) on the right is the one discussed in this section. See Figure
4-42.
The Hard Drive Slots
Chapter 4
Changing Your Workstation's Hardware Configuration
Hard Disk Drives
Hard Disk Drive
SCSI slots
SCSI ID 6
SCSI ID 5
123