Setting The Monitor Type At Power On - HP Visualize c3700 Owner's Manual

NOTE
Path
---------- ----
GRAPHICS(0)
Press [Return] to select this monitor type (type n of n types).
The Boot Console Interface
Displaying and Setting the Monitor Type

Setting the Monitor Type at Power On

If you replace your workstation's monitor with a different monitor type,
you need to let the workstation's firmware know you made this change.
To do this, reboot the system and use either the automatic monitor
selection process or the boot console interface's monitor command. The
monitor command is described in the section "Setting the Monitor Type"
in this chapter. The automatic monitor selection process is described in
this section.
Once you have rebooted the system by turning it off, wait for a short time
for the hard disk drive's disk to stop spinning. Next, turn the workstation
on and watch for the Num Lock light to come on.
It takes a short amount of time (approximately 40 seconds) after
powering on the workstation before the Num Lock light comes on.
Wait two seconds after the Num Lock light comes on, which is near the
end of the boot sequence, then press
selection process. If your screen remains blank after two minutes of
waiting for something to be displayed, see the section "Troubleshooting
Monitor Problems" in this chapter. Otherwise, if you see information
similar to the following displayed on your screen and it is the correct
monitor type, press the
Slot Head Type
---- ---- ------------ ----
0 1 n
Note that if you do not select this monitor type, the system cycles
through a limited number of monitor types one at a time until you find
one that meets your needs.
170
to initiate the automatic monitor
Tab
key to select it.
Enter
Size Freq
nnnn x nnnn nn Hz
Class
-----
VESA
Chapter 5