WARNING
Changing Your Workstation's Hardware Configuration
Left Side Panel
Left Side Panel
This section explains how to open and close the left side panel of the
workstation. This side panel will have to be opened whenever you need
access to the internal components of the workstation.
Opening the Left Side Panel
Perform these steps to open the left side panel.
Always unplug the workstation's power cord from the electrical
outlet or power source before opening the workstation.
1. Power off the workstation, and unplug the workstation's power cord
from the electrical outlet.
2. Attach the static-grounding wrist strap by following the instructions
on the package. Attach the sticky end of the wrist strap to bare metal
on the back panel of the workstation.
3. Turn the workstation around so its back is facing you. On the right
edge of the workstation, there are two T-15 Torx thumbscrews as
shown in Figure 4-2. Remove the two T-15 Torx thumbscrews.
78
Chapter 4