Installing a Slim Floppy Disk Drive
To install a slim floppy disk drive, take the following steps.
1 Remove the cover (refer to "Removing the Cover" on page 14).
2 Remove the front panel chassis (refer to "Removing the Front Panel Chassis"
on page 16).
3 If the floppy disk drive is not already connected to its tray, connect it now.
Front of floppy
disk drive
4 screws (2 on either side) to connect the floppy
disk drive to the floppy disk drive tray
4 By pushing outwards from the inside with your fingers, remove the floppy disk
drive plastic filler panel from the front bezel. If you need to remove the front
bezel to do this then do so by unclipping the bezel from the front panel chassis.
5 clips used to connect the front
bezel to the front panel chassis
Side view of floppy disk drive and
floppy disk drive tray
Floppy disk drive plastic filler panel
Installing a Slim Floppy Disk Drive
21