Installing A Floppy Disk Drive - HP Visualize b1000 - Workstation Owner's Manual

WARNING
CAUTION
Changing Your Computer Hardware Configuration
Removable Media Devices
8. Replace the plastic CD drive blank in the computer's front panel.
9. Replace the left side panel and front panel of the system unit as
explained in the sections "Closing the Left Side Panel of the System
Unit" and "Closing the System Unit Front Panel" in this chapter.

Installing a Floppy Disk Drive

Install the floppy disk drive by following the procedure covered in this
section. Note that there are no jumper settings required for the
installation of the floppy disk drive.
Turn the system unit off and unplug the power cord before
installing the floppy disk drive.
Floppy disk drives are susceptible to mechanical and electronic shock.
When handling the drive, always wear the static-grounding wrist strap
that came in the floppy disk drive kit. Always handle the drive carefully.
1. Perform the procedures in the sections "Opening the System Unit
Front Panel" and "Opening the Left Side Panel of the System Unit."
The front panel needs to be opened so you can insert the floppy disk
drive into its proper location in the chassis. The left side panel needs
to be opened so you can get to the floppy's data connector and its
power connector.
126 Chapter 5