Drive Error Codes; Drive Error Codes - IBM System Storage TS3400 Tape Library Maintenance Information

Table 1-1. Library error codes (continued)
Code (H) Description
Sensor error #7.
During blink check, a Y
00F8
encoder sensor error was
detected.
Sensor error #8.
During blink check, an X
00F9
encoder sensor error was
detected.
Sensor error #9.
During blink check, an
00FA
I/O slot sensor error was
detected.
Sensor error #10.
During blink check, a
00FB
magazine (Upper) sensor
error was detected.
Sensor error #11.
During blink check, a
00FC
magazine (Lower) sensor
error was detected.
Sensor error #12.
During blink check, an X
00FD
origin sensor error was
detected.

Drive Error Codes

Table 1-2. Drive error codes
Code (H) Description
Invalid data was sent to
Drive #1.
0200
NAK was detected.
A timeout error occurred
0201 while waiting for response
from Drive #1.
0203 Drive #1 is disconnected.
0205 Drive #1 is busy.
Drive #1 failed to execute
0206 a command because drive
could not be mounted.
Panel
Indication
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
CHK 00F8
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
CHK 00F9
CHK 00FA
CHK 00FB
CHK 00FC
CHK 00FD
Panel
indication
1. Confirm the drive connection.
CHK 0200
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
4. Replace the drive canister (page 9-11).
CHK 0201
5. Replace the Drive Docking Card (page 9-19).
6. Replace the Back Board assembly (page 9-37).
CHK 0203
7. Replace the TS3400 Tape Library chassis (page 9-44).
CHK 0205
CHK 0206
Action Required
Action Required
Chapter 1. Start Service
1-15