Placing The Library In The Rack; Sliding Library Into The Rack - IBM System Storage TS3400 Tape Library Maintenance Information

Placing the Library in the Rack

The library slides into position on the rack shelf and is secured in position by screws
through the mounting brackets.
Before proceeding with the installation of the library, ensure that you have removed
all the library components by following the procedures in "Removing Components to
Reduce Library Weight" on page 6-2.
Figure 6-17. Sliding library into the rack
To place the library in the rack:
1. With a person on each side of the library, lift the library.
2. Slide the library partially onto the rail shelves in the rack.
3. Push the library into the rack until the mounting bracket contacts the front
4. Insert and tighten the thumb screws on the mounting brackets (
5. Finally, push the clip-on bezels (
6-16
TS3400 Tape Library Maintenance Information
vertical rail posts.
into the front vertical rail posts.
mounting brackets to complete the rack installation.
in Figure 6-18) into the retainers on the
2
in Figure 6-18)
1