Table of Contents
Advertisement
7. Connect to the target node by typing telnet nodeid.
8. Start the tape utility program on the target node by typing tapeutil at the
9. Choose Tape Drive Service Aids from the menu, and press Enter.
10. Choose Microcode load from the following panel, then press Enter.
11. Select a Device, and press F7=Commit from the following panel. You must press
12. Enter the filename in the source field. (Example: /tmp/3592.fmr)
8-20
TS3400 Tape Library Maintenance Information
Enter a login id and a password when prompted.
prompt.
IBM Tape Device Service Aid Menu
Select One of the Service Aids to be performed
Force Microcode Dump
Perform a microcode dump of the system. The dump is stored in
the device.
After the dump is performed it must be read using Read Dump.
Read Dump
Transfer a dump from the tape device to a host file, diskette or
a tape cartridge.
Microcode load
Down-load microcode from host file or diskette to tape device via
SCSI bus.
Error Log Analysis
Analyze system error log for device.
F7=Commit after selecting the drive.
IBM Tape Device Selection Menu.
Select One of the devices listed below.
NAME
LOCATION
rmt2
00-05-01-10 IBM 3592 Tape Drive and Medium Changer
rmt3
00-05-01-30 IBM 3592 Tape Drive and Medium Changer
F3=Cancel
F7=Commit
You must press F7=Commit after entering the filename.
TYPE
F10=Exit
700000
900000
Advertisement
Table of Contents
