IBM System Storage TS3400 Tape Library Maintenance Information page 51

Table 1-11. Drive FID codes (continued)
FID
BF The drive detected a drive canister fan fault.
C1 The drive detected that an input voltage is out
of range, a power supply has failed, or a
power supply cooling fan has failed.
D8 The drive detected degraded drive hardware.
The drive will continue to operate, but with
degraded performance.
E4 The drive detected a drive electronics fault.
E5 The drive detected a drive microcode fault.
E6 The drive detected a timing problem in the
drive microcode or drive electronics.
ED The drive detected that a drive dump has
been written to flash memory.
F2 The drive detected a drive hardware or media
fault.
F4 The drive detected a problem with the RS-232
library to drive interface.
F5 The drive detected a problem with the Fibre
Channel host interface.
F6 The drive reported an informational message
- drive cleaning is required.
F7 The Fibre Wrap Test failed.
(Probability 90% drive canister, 10% Fibre
channel cable)
FE The drive detected a cartridge/media
problem.
FF The drive reported an informational or
non-hardware status or error.
Description Action Required
Drive canister problem. See "Replacing a Tape Drive
Canister or FC 1663 Tape Drive Removal" on page 9-11.
• Verify that library power is getting to the drive sled (drive
LEDs are ON and the fan is turning). If power is missing
from the drive, see "Replacing a Power Supply Unit" on
page 9-7.
• If power is OK, this is a drive canister problem. See
"Replacing a Tape Drive Canister or FC 1663 Tape Drive
Removal" on page 9-11.
Drive canister problem. See "Replacing a Tape Drive
Canister or FC 1663 Tape Drive Removal" on page 9-11.
Drive canister problem. See "Replacing a Tape Drive
Canister or FC 1663 Tape Drive Removal" on page 9-11.
• Firmware problem. See "Methods of Updating Firmware"
on page 7-20.
• Drive canister problem. See "Replacing a Tape Drive
Canister or FC 1663 Tape Drive Removal" on page 9-11.
• Try reloading the drive microcode. See "Methods of
Updating Firmware" on page 7-20.
• Report to your next level of support.
Status message that a dump is in flash memory. To offload a
dump to flash or clearing flash dump memory, see
"Downloading Drive Logs" on page 7-16.
See FID 86 in this table.
• Reseat the drive canister.
• If the problem persists, offload a microcode dump and
contact your next level of support.
Host interface, operational procedure, or host problem.
Host interface, operational procedure, or host problem.
If you were running the Fibre Wrap Test, check the following
before you replace the drive canister.
1. If you were running the Fibre Wrap Test at the drive
itself, ensure that the wrap tool is making a good
connection or try a different wrap tool. Rerun the test to
ensure that the drive canister is at fault.
2. If you were running the Fibre Wrap Test through the
Fibre cable, try the Fibre Wrap Test at the drive. It the test
runs without error at the drive, replace the cable. If the
test still generates FID F7, replace the drive canister.
See FID 87 in this table.
Operational procedure or host problem.
1-35
Chapter 1. Start Service