6. Review the cable connections to the library. If you need to disconnect the cables
7. Determine whether you will need to take the library offline to service the library.
8. Contact the library administrator to schedule a time to take the library offline, if
9. Power OFF the library if required.
10. Add, remove, and replace each part, as necessary.
11. Power ON the library and run the appropriate diagnostic and library verification
12. Take the library online after you finish adding, removing, and replacing all
13. Clear all open Operator Interventions.
14. Verify that your host applications can communicate with all drives and the
15. Generate another log of the status of the library after verifying that the library is
16. Complete the steps in "End of Call" on page 7-26.
Service Mode Menu
The Service Mode menu on the Operator Panel gives service personnel access to
troubleshooting and maintenance diagnostic tools. This section describes menu items
that are used specifically by maintenance personnel when servicing the library.
Figure 7-1. Operator Panel Service Mode menu
Checking the Library Error Status
Figure 7-2. Error status menu
Use Service Mode → Error Status to check the current status of the major library
components.
to remove or replace a field replaceable unit (FRU), consider labeling the cables
so you can reconnect them correctly.
See "Required Library State for Repairs" on page 9-2.
necessary. Before taking the library offline, ask the administrator to complete or
cancel any jobs that are in the queue.
tests in the Service Mode menu after servicing the library.
necessary parts. See "Taking the Library Offline/Online" on page 7-23.
library.
repaired and running smoothly.
Service Mode
Error Status
Error Log
Statistics
Diagnostics
Drive Replacement
Service Mode
Error Status
Accessor
Drive 1
Drive 2
Chapter 7. Service Procedures
7-3
Need help?
Do you have a question about the System Storage TS3400 Tape Library and is the answer not in the manual?
Questions and answers