Table of Contents
Advertisement
AJCUHQV2
Select one of the following:
Selection
_
F3=Exit
The following screen is displayed when the verification test completes
successfully:
AJCUHQV3
The verification test completed successfully.
Press Enter to continue.
5. When the Tape Device Test menu is displayed, select Exit test menu 3.
Checking Channel Attachment – pSeries/RS6000 AIX
The devices must be fully installed and the host device driver must be configured and
available. See IBM SCSI Tape Drive, Medium Changer, and Library Device Drivers:
Installation and User's Guide for information about installing and using the IBM tape
drive, medium changer, and library device drivers. Also, "Installation and
Configuration Instructions" in the above guide describes the smit and cfgmgr
commands.
Figure 8-2 shows an example of software and hardware paths that are used in the
following tests. The figure illustrates the unique initiator addresses for a
configuration with more than one initiator sharing a fibre channel.
1. Basic read/write test 2
2. Read/write reliability test
3. Exit test menu 3
Tape Problem Analysis
Tape Device Test Menu
Chapter 8. Drive Maintenance Procedures
8-25
Advertisement
Table of Contents
