IBM System Storage TS3400 Tape Library Maintenance Information page 25

Table 1-1. Library error codes (continued)
Code (H) Description
In GET (remove cartridge
from drive) operation,
cartridge cannot be ejected
007C
because the drive does not
enter EJECT state after 200
seconds have elapsed.
In PUT (put cartridge into
drive) operation, cartridge
cannot be put because the
007D
drive does not enter
MOUNT state after 200
seconds have elapsed.
In PUT (put cartridge into
drive) operation, the drive
007E does not enter SET state
after 3 seconds have
elapsed.
In PUT (put cartridge into
drive) or GET (remove
cartridge from drive)
007F operation, the assigned
drive and interface
communication fails or is
disconnected.
X movement error #1.
During X movement, an
0080
error occurred in the
target stop position's
origin sensor detection.
X movement error #2.
During X movement, the
0081
motor lost sync with
commanded position.
X movement error #3.
During initialization, the
0082
motor lost sync with
commanded position.
During removal of
cartridge from a drive and
0083 transferring it to a storage
slot, the X origin sensor
could not be detected.
During initialization, the
0084 X origin position could
not be detected.
Panel
Indication
1. Cycle the power and try again.
2. Check for presence of media in the drive.
3. Replace the media.
4. Replace the Library Control Blade (page 9-8).
CHK 007C
5. Replace the drive canister (page 9-11).
6. Replace the Drive Docking Card (page 9-19).
7. Replace the Back Board assembly (page 9-37).
8. Replace the TS3400 Tape Library chassis (page 9-44).
1. Cycle the power and try again.
2. Check for presence of media in the drive.
3. Replace the media.
CHK 007D
4. Replace the Library Control Blade (page 9-8).
5. Replace the drive canister (page 9-11).
6. Replace the Drive Docking Card (page 9-19).
7. Replace the Accessor assembly (page 9-23).
8. Replace the Accessor Flat Cable Plate assembly (page 9-28).
CHK 007E
9. Replace the Back Board assembly (page 9-37).
10. Replace the TS3400 Tape Library chassis (page 9-44).
1. Confirm the drive connection.
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
CHK 007F 4. Replace the drive canister (page 9-11).
5. Replace the Drive Docking Card (page 9-19).
6. Replace the Back Board assembly (page 9-37).
7. Replace the TS3400 Tape Library chassis (page 9-44).
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
CHK 0080
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
CHK 0081
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
CHK 0082
CHK 0083
CHK 0084
Action Required
Chapter 1. Start Service
1-9