IBM System Storage TS3400 Tape Library Maintenance Information page 29

Table 1-1. Library error codes (continued)
Code (H) Description
Gap status irregularity
00BF detected at the completion
of Accessor operation.
Accessor operation is
disabled because a
00C0
cartridge magazine was
removed.
CTRG. calibration error
#1.
00C8
During CTRG. calibration,
CTRG. sensor OFF could
not be detected.
CTRG. calibration error
#2.
00C9
During CTRG. calibration,
CTRG. sensor ON could
not be detected.
A checksum error was
00D0 detected during updating
the firmware.
Firmware ID error was
00D1 detected during updating
the firmware.
An error was detected in
00D2 boot information during
updating the firmware.
Redundant power supply
00D6
unit #1 error detected.
Redundant power supply
00D7
unit #2 error detected.
Panel
Indication
1. Cycle the power and try again.
2. Confirm the media is fully seated in magazine.
3. Replace the Library Control Blade (page 9-8).
CHK 00BF 4. Replace the Accessor assembly (page 9-23).
5. Replace the Accessor Flat Cable Plate assembly (page 9-28).
6. Replace the Back Board assembly (page 9-37).
7. Replace the TS3400 Tape Library chassis (page 9-44).
1. Confirm the magazine is closed.
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
CHK 00C0 4. Replace the Accessor assembly (page 9-23).
5. Replace the Accessor Flat Cable Plate assembly (page 9-28).
6. Replace the Back Board assembly (page 9-37).
7. Replace the TS3400 Tape Library chassis (page 9-44).
Cycle the power and try again.
CHK 00C8
CHK 00C9
1. Check the firmware file version.
CHK 00D0
2. If firmware is correct, reinstall the firmware.
3. Replace the Library Control Blade (page 9-8).
4. Confirm/Replace the power supply units (page 9-7).
CHK 00D1
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
CHK 00D2
1. Replace redundant power supply unit 1.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Back Board assembly (page 9-37).
4. Replace the TS3400 Tape Library chassis (page 9-44).
Alarm LED
ON
1. Replace redundant power supply unit 2.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Back Board assembly (page 9-37).
4. Replace the TS3400 Tape Library chassis (page 9-44).
Action Required
Chapter 1. Start Service
1-13