Library Door Screw Locations - IBM System Storage TS3400 Tape Library Maintenance Information

8. On the front panel, remove the front bezel. See "Replacing the Front Bezel" on
9. Remove the five screws securing the library door (
Figure 9-23. Library door screw locations
10. Pull the library door open.
11. Placing your fingers over the bottom front lip of the Accessor assembly, pull the
12. Disconnect the two flat cable connectors on the front right of the Accessor
9-24
TS3400 Tape Library Maintenance Information
page 9-14.
frame.
Accessor assembly to the front of the library.
assembly (Figure 9-24). Release the connector lock by pulling out the top and
bottom edges of the lock tab (
out of the connector.
Note: See Figure 9-25 for a close-up view of the flat cable as it mates with the
connector. The cable contacts are aligned with the connector contacts and
are held in place by pressing the slide lock in to wedge the cable and
connector together.
in Figure 9-23) to the library
1
1
in Figure 9-25), and then withdraw the flat cable
1