Display Toll Table Entries - Vodavi STARPLUS Triad-S Manual

Toll Restriction
To enter office codes in a special table:
1. Press the SPECIAL TABLE (#1 to #4) flexible button (FLASH 70, Buttons #5 to #8) that
corresponds to the area code programmed above. The following message displays:
2. Enter the office codes that are to be allowed or removed as follows:
XXX [1] = Allow Code
XXX [0] = Remove Code from the list
3. Press HOLD after every code entered. A confirmation tone sounds and the display
updates. Multiple codes may be entered in a row. The display updates showing the first
six codes in ascending order.
DEFAULT ... No codes are on the Allow list.

Display Toll Table Entries

Description
To view all entries in the toll tables using the display on the Executive telephone, press, the
DISPLAY TABLES flexible button (FLASH 70, Button #12) multiple times to scroll through the
entries.
Programming Steps
Press the DISPLAY TABLES flexible button (FLASH 70, Button #12) while entering
information into a table.
To view entries in an allow or deny table:
Two entries at a time are displayed on the bottom line of the display.
1. Press the DISPLAY TABLES button again, the next higher bins displays.
2. When the last entries are displayed, press the DISPLAY TABLES button again to show the
first two entries.
To view entries in a special table:
Six 3-digit codes allowed display in ascending order starting with the lowest entry.
S PE C I AL TA B LE 1
XXX = Area Code
(XXX = An office code from 200 to 999)
It is recommended to view all entries in the Allow and Deny Table before leaving
programming. Entries can be entered near the bottom of the list for searching the
special tables or entries made in error. Viewing the entire Allow Table ensures
proper entry and operation.
A LLO W TA B LE A
0 1 X X X X XX X E
X = Allow or Deny Code
E = End of Entry
Chapter 2 - Features and Operation
AC X X X
0 2 X X XX X X X X
2-247