Release Button; Speed Dial - System Storing - Vodavi STARPLUS Triad-S Manual

3-22
Chapter 3 - Attendant Features and Operation
Programming Steps
1. Press the ATTENDANT RECALL TIMER flexible button (FLASH 01, Button #3). The
following message displays:
2. Enter a valid number on the dial pad that corresponds to 00-60 minutes.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Attendant Recall Timer is set for 1 minute.

Release Button

Description
The Release Button feature lets the station user disconnect calls while off-hook (on handset,
not speakerphone), speeding up call handling time.
While off-hook (on handset, not speakerphone) on an intercom call, transfer sequence, page
announcement, or CO call:
Press the preprogrammed RELEASE button [641] to terminate intercom call, transfer
sequence, page announcement or CO call.

Speed Dial - System Storing

System Speed numbers must be entered by the first programmed Attendant. If no Attendant
is specified, enter at Station 100.
1. Press SPEED once, then press desired outside line key; or select an outside line
automatically by pressing the SPEED button twice.
2. Dial the System Speed bin location (9020-9999).
3. Dial telephone number.
4. Press the SPEED button.
5. Hang up.
Speed Bin numbers 9060-9099 ARE NOT monitored by Toll Restriction.
ATN D R E C AL L T IM E R
0 1
Pressing the TRANS button during number entry initiates a Pulse-To-Tone switchover.
Pressing the HOLD button during number entry inserts a Pause.
Pressing the FLASH key inserts a Flash into the speed number.
Pressing the TRANS button as the first entry in the speed bin inserts a no-display
character causing the numbers stored in the bin not to display on the Digital
Telephones when the bin is accessed.
0 0-60
Release Button