2-206
Chapter 2 - Features and Operation
Operation
If your phone has been programmed for Off-Hook Preference, you can access an outside line,
or a feature by going off-hook or pressing the ON/OFF button. It simulates the depression of
a specific button and can be programed by a station user or a database administration
programmer using code [691] + the button number.
While Off-Hook Preference is enabled, you may access internal intercom dial tone as
follows:
1. Press the preprogrammed ICM button,
-or-
Dial your intercom number. (Do not lift handset or press ON/OFF button before dialing
intercom number.) LED lights steady and intercom dial tone sounds.
2. Dial an internal station or feature access code.
Off-Hook Preference Programming (Via a Station)
If your phone is programmed for Off-Hook Preference and you were given the ability to
enable or change the prime flexible button:
1. Dial [691] on the dial pad.
2. Dial the desired button number. Refer to the following chart.
To disable Off-Hook Preference:
1. Dial [691] on the dial pad.
2. Dial [00] on the dial pad.
SINGLE LINE TELEPHONES
When establishing an Off-hook Preference for SLT stations, it is necessary to program the
SLTs CO line or line group, to access when going off-hook. To program this, refer to
a CO Line Group for an SLT (with off-hook preference):" on page
Conditions
»
Single line telephones can bypass Off-hook Preference by doing a hookflash and then
dialing their extension number.
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
01
02
❋
❋
05
06
❋
❋
09
10
❋
❋
13
14
❋
❋
17
18
❋
❋
21
22
❋
❋
Ring Down/Hot Line/Off-Hook Preference
03
04
❋
❋
07
08
❋
❋
11
12
❋
❋
15
16
❋
❋
19
20
❋
❋
23
24
❋
❋
2-132.
"To assign